|
CBE FERTILITY MONITOR--Question About Re-Setting
| Posted By |
Message |
KeriNY
LIF Infant

Member since 7/07 181 total posts
Name: Keri
|
CBE FERTILITY MONITOR--Question About Re-Setting
I used mine for two months only, themnended up pregnant trough IVF.
Anyway, my friend wants to use it. Any advice or tips on how to reset it for her use? I know when I used it, it wasn't starting my cycle til day 9, not 7 since I had long cycles.
Thanks
Message edited 4/10/2008 2:55:34 PM.
|
Posted 4/10/08 2:53 PM |
| |
|
Long Island Weddings
Long Island's Largest Bridal Resource |
HoneyBadger
YourWorstNightmare.

Member since 10/06 15979 total posts
Name: BahBahBlackJeep
|
Re: CBE FERTILITY MONITOR--Question About Re-Setting
Hmmm... I'm not sure b/c it's reading your cycle so it's already in that mode.
Did you check the manual that comes with it? I know you can change the test day (meaning the first day of your cycle for testing purposes, but I would think it's still going to work based off your cycle.
|
Posted 4/10/08 3:29 PM |
| |
|
cazhley
I ♥ cheesiness.

Member since 1/07 1429 total posts
Name: Cassie
|
Re: CBE FERTILITY MONITOR--Question About Re-Setting
Here are some instructions posted by users at ovusoft.com. (I haven't tried these.) ovusoft forum
"Please read all instructions over before attempting to re-set the monitor!
1. With the monitor off, place a clean unused test stick with the cap on (remove plastic cap from one end and snap it onto the other end of stick) in the test stick slot of the monitor.
2. *Make sure it snaps in.*
3. Press and hold the "m" button. Continue pressing the "m" button while turning the monitor on. NOTE: Do not take finger off "m" button until these directions say to do so.
4. It will show you the "remove the test stick" sign. (a flashing test stick with an arrow pointing right) Continue pressing "m".
5. Keep pressing the "m" button and in about 20 seconds, you will see a screen full of symbols. The screen will look as if it is going crazy and will be full of pics.
6. Remove the test stick first and then QUICKLY release your finger from the "m" button. All of the memory should be wiped out.
7. Your screen should display a flashing "m" and one or two dashes. If it does not, it will probably show a "1" and a non-flashing "m". If it does, then you need to repeat the process so it shows the flashing "m" and dashes.
8. Start using the monitor on CD1 as per the instruction booklet."
|
Posted 4/10/08 4:35 PM |
| |
|
KeriNY
LIF Infant

Member since 7/07 181 total posts
Name: Keri
|
Re: CBE FERTILITY MONITOR--Question About Re-Setting
WOW..this is GREAT.. Thank you SO MUCH!
|
Posted 4/10/08 5:40 PM |
| |
|
toni-mike
???????

Member since 10/07 1196 total posts
Name: Toni
|
Re: CBE FERTILITY MONITOR--Question About Re-Setting
there is also a 800 to call & they will guide u thru the whole re set thing
|
Posted 4/11/08 12:22 PM |
| |
|
Potentially Related Topics:
Currently 1893731 users on the LIFamilies.com Chat
|