|
| Posted By |
Message |
Megan1129
LIF Adolescent

Member since 3/09 515 total posts
Name: Megan
|
Closet Reno
We closed on our house in September and have been doing renovations since. I'll def post pictures once the kitchen and bathroom are fully done. In our bedroom, the only thing we really want to do is combine closets. We have two really small his/her closets side by side and want to make it one large closet. Has anyone done this and know how much work is entailed? We would be doing this ourselves. Thanks!
|
Posted 3/1/12 7:31 AM |
| |
|
Prudential Douglas Elliman Real Estate
Long Island's Largest Bridal Resource | Long Island Weddings |
nraboni
Uggh...
Member since 10/09 6905 total posts
Name: Nicole
|
Re: Closet Reno
We had closets that backed up against each other and turned it into a large walk-in closet.
It's not hard to do and since yours are side by side, I'm sure there isn't a support beam between them.
It will be messy to demo it but the only materials you will need to buy are sheetrock, sheetrocks screws, tape and spackle.
Of course once you are done you will need to get paint and closet organizers.
|
Posted 3/1/12 9:43 AM |
| |
|
GoldenRod
10 years on LIF!

Member since 11/06 26792 total posts
Name: Shawn
|
Re: Closet Reno
Closet walls typically aren't load-bearing, but you need to verify that. If they aren't load-bearing, you can just take the doors down, and the separating walls, then rebuild whatever structure you need to fit the new layout. You'll need to do some carpentry, since you'll need to build the structure to support the doors.
What type of door(s) were you thinking of using? Sliding, bi-fold, single hinged door?
You could probably get most of it done in one day. The complete project will have to be about a week, since you'll need time for the spackle to dry, then the primer, then the paint, but it's a day or two of actual work.
|
Posted 3/1/12 10:06 AM |
| |
|
Megan1129
LIF Adolescent

Member since 3/09 515 total posts
Name: Megan
|
Re: Closet Reno
Thanks for the feedback. I couldn't picture it taking that long to do.
I know the question of load bearing was on my mind. How do you check or know if it is load bearing?
In my mind, I picture just knocking down the wall in between the closets and the frame in between the closets. And then just restructuring the frame and like you said, spackling, and painting. Am I simplifying it too much. I think we would want to do bifold doors. That's what we had in our previous apartment and we really liked the ease of it.
|
Posted 3/1/12 10:53 AM |
| |
|
GoldenRod
10 years on LIF!

Member since 11/06 26792 total posts
Name: Shawn
|
Re: Closet Reno
Posted by Megan1129
Thanks for the feedback. I couldn't picture it taking that long to do.
I know the question of load bearing was on my mind. How do you check or know if it is load bearing?
In my mind, I picture just knocking down the wall in between the closets and the frame in between the closets. And then just restructuring the frame and like you said, spackling, and painting. Am I simplifying it too much. I think we would want to do bifold doors. That's what we had in our previous apartment and we really liked the ease of it.
That's essentially all there is. If the ceiling joists are parallel to the closet wall, it's definitely not load-bearing. If the doors don't have a solid header over them, it's not load-bearing. If there are no doubled-up studs at any critical spots (door frames, corners, etc.), it's probably not load-bearing. The "real" wall, at the back of the closet, that defines the room is pretty much always the load-bearing wall.
We have several closets with bi-fold doors. Pretty much all of the weight of the door is supported by the side frame, not the top, which makes things even easier.
|
Posted 3/1/12 10:59 AM |
| |
|
Megan1129
LIF Adolescent

Member since 3/09 515 total posts
Name: Megan
|
Re: Closet Reno
Thanks so much for your explanation
|
Posted 3/1/12 12:09 PM |
| |
|
Potentially Related Topics:
Currently 1121698 users on the LIFamilies.com Chat
|
Long Island Bridal Shows
|