Re: Nautilus vs. Frontier
Posted 2/21/2012 3:07:35 PM by tara73


Posted by LSP2005


Posted by tarabelle99

Frontier can be difficult to install with a seat belt in some vehicles this becomes important as LATCH use must be discontinued when a child reaches 40/48lbs depending upon vehicle. If you do get one, stay away from the mesh like covers, they tend to pill up, there's been a lot of complaints about that.

I would go play with them, and also check out the new seats that are out:

BabyTrend TrendZ FastBack
Evenflo Secure Kid 300/400
Graco Argos.



This advice does not apply to the Britax Parkway SGL according to the manufacturer.

Per Britax:

Q. Is it ok to use the LATCH/Universal Anchoring System on the BRITAX PARKWAY SGL booster seat up to 120 lbs?
A. Yes, the vehicle seat belt is bearing the crash loads and not the LATCH anchors since the LATCH anchors are just holding the seat in place and the vehicle seat belt is what is being used to restrain the child. The load of the child (weight X speed) is applied to the vehicle seat belt as that is what is restraining the child.



LATCH weigh limits apply to harnessed seats. A vehicle manufacturer AND car seat manufacturer both have limitations, although one may defer to the other. MOST vehicles and harnessed seats have a limit of 40 or 48lbs for car seats. In the case this thread, the seats being discussed are 5 point harness COMBINATION seats (Frontier, Nautilus - sometimes also called "harnessed boosters"). They are treated the same as infant and convertible seats when used in harness mode, therefore the lower anchors and connectors all have weight limits assigned to them (or will defer to the other, if both defer then you discontinue at 40lbs). You will always use the LOWER limit (so if the vehicle limit states to discontinue use and reinstall with a seat belt at 40lbs you do it at 40 even if the carseat says 48)

Parkway is a belt positioning booster seat, not a harnessed booster/combination seat, used with the adult seat belt, not a 5 point harness. The only purpose to LATCH a booster in place is to hold it there and prevent it from being a projectile when unoccupied. The SEAT BELT is what is restraining the child, not the LATCH connectors. Because the seat belt is what is absorbing the force and not the lower anchors, the lower anchors can not fail as they are not restraining the seat at all. Britax clearly states this in their answer. Also, it's important to note the Parkway is a bit unique amongst boosters because it not only allows LATCH use but has the antisubmarine SlideGuard that is attached between the legs (that is the "SG" of the SGL, the L is LATCH.) By contrast, a harnessed seat is restraining the child AND absorbing the crash forces, as is the mechanism holding the seat in and the connectors/anchors are tested to load limits.
Print Post      Close Window