Re: cbefm users????
Posted 8/7/2010 9:15:10 PM by smdl

To reset for memory reset... The other poster is talking about resetting to use every month after AF and a new cycle.


You will need a new stick.


•Step1
Remove the plastic cap from one end of a clean, unused test stick. Snap the cap onto the other end of stick. Insert the test stick into the test stick slot of the monitor. The beveled corner on the insertion end of the stick must face in toward the monitor, with the point up - slide the stick to the left until it snaps into place. THE STICK MUST SNAP INTO PLACE TO PERFORM PROPERLY. The monitor should not be turned on until step 2.

•Step 2
Press and hold down the "M" button. Continue depressing the "M" button while turning the monitor ON. NOTE: Do not take finger off the "M" button until these directions say to do so in STEP 5.

•Step 3
The screen will show the "remove the test stick" symbol (a flashing test stick with an arrow pointing to the right). Continue holding the "M" button down - do NOT remove the stick yet.

•Step 4
Keep holding the "M" button and in about 20 seconds you will see a screen full of symbols. These are the same symbols that are displayed when the brand new monitor is turned on for the FIRST time. These symbols indicate that the memory is now cleared of all prior data.

•Step 5
Remove the test stick first and then QUICKLY release your finger from the "M" button. The memory should now be cleared.

•Step 6
Your screen should now display a flashing "M" and one or two dashes. If it does not, it will probably show a "1" and an "M" in a non-flashing mode. If so, you will need to repeat all steps of the process. This procedure may take several times before you successfully reset the unit to its "new" state.

•Step 7
Start using the monitor on CD 1 to 5 as per the instruction booklet.


Print Post      Close Window